Concrete block walls or Masonry block walls are common walls providing several advantages. Construction concrete block layers are quite easy but need precision and patience for getting the next project. Here are some essential tips which you could follow for building an awesome concrete block wall. Ensure you have the right type of block for your project and also consider getting some standard blocks & half blocks with rounded or square corners. The right kind of concrete masons and wall installation services can help you in this regard.
 |
| Concrete Work |
What are the Steps Involved in Laying the Right Type of Concrete Blocks?
Stake the wall
Begin by marking the exterior side of concrete block wall perimeter. Create the stakes by rubbing a mallet & uses a thread line which will assist you to determine whether the lines are straight or not.
Set-Up A Foundation
The second step involves the laying up of the foundation. Generally, foundations for masonry or concrete block walls are created of high-quality concrete and mortar mix, and they must be at least 4 inches wider compared to the block width. The mason should allow the foundation made up of concrete to acquire enough strength. When the wall of the block is constructed over the existing concrete slab, ensuring that the surface is moisture and the 1-inch motor bed has been widespread over the footing.
 |
| Commercial Bricklaying |
Understand How to Lay Concrete Blocks
Start mixing mortar mixture as instructed. The first layer of blocks must be kept below the floor level & inside the trench of the foundation. Equally spread mortar alongside the blocks and neglect the excess mortar using the trowel. Repeat till the first layer gets installed properly. It is always advisable to go for trained mortar and bricklaying professionals who know the right amount of mixing concrete and putting them on layers.
Implementing the Second Layer of Block Wall
Repeat the action carried out in the previous step to include another layer of blocks. Blocks can be created in such a way that it will formulate an interlocking pattern meaning that the end of one layer of blocks can sit above the center of other blocks below them. Keep on installing blocks and try to implement about 6 layers per day. Give some time for the motor to set fully before continuing to place another layer of concrete blocks.
How to Easily Cut the Concrete Blocks
At any one point, the concrete blocks have to be cut so that they can be perfectly installed around the joints or corners. The perfect means to cut the concrete block is by using hammer & chisel to develop a line where you need desired cut. Be cautious on not to apply adequate force while hammering because the block could split into smaller pieces.
Structural Masonry or Concrete Walls
When the concrete block layer needs to be reinforced then, it is essential to consider for a structural masonry wall. Vertical reinforcement can be implemented within the block cells & filled with mortar. Horizontal reinforcement must be required as well, by making use of prefabricated welded wires which are situated along the horizontal lines in between the layers.
When the wall is created as an exterior block wall then masonry is suggested. The block layers in the construction field will be installed and barrier must be offered on the exterior surface like breathable, fluid-applied masonry coating or over-classing to thwart water penetration towards the masonry. Laying the concrete blocks is not just part of the construction of the home, but you can also use the block layers of concrete for landscaping your garden area. Also, laying the mortar before it is finally hardened is very essential, as that will ensure the fine laying of concrete.
0 comments:
Post a Comment